OHP transparencies

Printer setup

Press the [Menu] key, select [Paper Input], [Paper Type: Bypass Tray], and then select [OHP (Transparency)].

Printer driver setup

Click [Bypass Tray] in "Input Tray:" list, and then click [Transparency] in the "Paper Type:" list.

Supported paper feed tray

This paper type can be printed only from the bypass tray.

Paper capacity

• Bypass Tray: 100

Make sure paper is not stacked higher than the upper limit mark ( ) inside the tray. When using the bypass tray, make sure paper is not stacked higher than the paper guides on the bypass tray.

Duplex printing

Not supported

Additional cautions

• Printing is slightly slower than when using plain paper.

• Due to switching modes, the printer will be on standby for thirty or forty seconds after the job was received.

• We recommend that you use a 4000 ANSI lumen or brighter overhead projector to project OHP transparencies.