Skip header
 

Setting the Ethernet Speed

You can set the speed that the printer will use for Ethernet communications. In most cases, this should be left on the default setting, [Auto Select]. This setting allows two interfaces to automatically determine the optimum speed when they are connected.

Router/HUB

Printer

[10Mbps Half Duplex]

[10Mbps Full Duplex]

[100Mbps Half Duplex]

[100Mbps Full Duplex]

[Auto Select]

10 Mbps half duplex

Power Off

-

-

-

Power Off

10 Mbps full duplex

-

Power Off

-

-

-

100 Mbps half duplex

-

-

Power Off

-

Power Off

100 Mbps full duplex

-

-

-

Power Off

-

auto-negotiation (auto selection)

Power Off

-

Power Off

-

Power Off

Important

  • Connection cannot be established if the selected Ethernet speed does not match your network's transmission speed.

  • The use of this feature is recommended. To use it, select [Auto Select].

1Press the [Menu] key.

Control panel illustration

2Press the [Down arrow key ] or [Up arrow key ] key to select [Host Interface], and then press the [OK] key.

Operation panel screen illustration

3Press the [Down arrow key ] or [Up arrow key ] key to select [Network], and then press the [OK] key.

Operation panel screen illustration

4Press the [Down arrow key ] or [Up arrow key ] key to select [Ethernet Speed], and then press the [OK] key.

Operation panel screen illustration

5Press the [Down arrow key ] or [Up arrow key ] key to select the Ethernet speed, and then press the [OK] key.

Operation panel screen illustration

6Press the [Menu] key to return to the initial screen.

7Print a configuration page to confirm the settings.

Note

  • For details about printing the configuration page, see "Test Printing".