Skip headerGelSprinter GX e2600/GX e3300N/GX e3350N/GX e7700N
ContentsPreviousNextHelp

If Test Print Fails

This section explains how to troubleshoot Test Print problems.

The power cord or USB cable or Ethernet cable is not properly connected.

Check that the power cord and USB cable, Ethernet cable are properly connected.

The port connection is not properly set.

  1. On the [Start] menu, click [Printers and Faxes].

  2. Click the icon of the printer, and then click [Properties] on the [File] menu.

  3. Click the [Ports] tab, and then check the printer port.

  • Select USB or network printer in the list when the selected port connection is something other than USB or network printer.

  • To connect via USB when USB does not appear in the list, you must re-install the printer driver. See USB Connection is not Automatically Detected.

Ink feed is incomplete.

Ink begins automatically feeding into the print heads when the power of the printer is first turned on or when a cartridge is replaced.

Wait until ink feed is complete at which point the [Power] key stops blinking and remains lit.

The printer is offline.

Check if the printer's on-line indicator is lit. If the printer is offline, press the [Online] key on the control panel to switch the printer to the on-line mode.

A printer error has occurred.

Use the control panel to check if a printer error has occurred. If it has, correct the error, and then perform the print again.

If you cannot solve the problem, contact sales or service representative.

Reference