Skip headerimage
ContentsPreviousNextHelp

Top Page > Troubleshooting > Paper Feed Problems > Removing Scanning Jams

Removing Scanning Jams

When the following message appears on the screen, follow the procedure below to remove the original jammed in the ADF:

"ADF Jam Open ADF Cover and Clear Jam"

  1. Open the ADF cover.

    image

  2. Gently pull the jammed original to remove it. Be careful not to pull the original too hard, as it may rip.

    image

  3. If you cannot pull out the jammed original easily, move the blue lever slightly to the machine rear, and then raise it to unlock the paper feed roller.

    image

  4. Lift the paper feed roller slightly and pull it out toward you.

    image

  5. Gently pull the jammed original to remove it.

    image

  6. If you cannot pull out the jammed original easily, raise the input tray to see if the original is jammed in the output area.

    image

  7. Gently pull the jammed original to remove it.

    image

  8. Put the paper feed roller back in with the roller part facing downwards.

    image

  9. Lower the blue lever to lock the paper feed roller.

    image

  10. Close the ADF cover.

    image

  11. Lift the ADF, and if there is original remaining in the ADF, gently pull the jammed original to remove it.

    Be careful not to hold the input tray when lifting the ADF, for the tray might be damaged.

    image

  12. Close the ADF.

TopPreviousNext
Copyright (C) 2009