Skip header
 

Top Page > Using the Copier Function > Making 2-sided Copies > Making 2-sided Copies Manually (Type 1 model)

Making 2-sided Copies Manually (Type 1 model)

This section describes how to make 2-sided copies manually.

1Place the odd-numbered pages of the original in the ADF.

2Press the [Copy] key.

3Press the [Start] key.

4Sort the output paper in reverse order.

5Load the output paper into the current tray.

If using tray 1 or tray 2, reload the paper with the blank side down; if using the bypass tray, blank side up.

Make sure to load paper with the top and bottom sides oriented correctly to avoid misprints.

6Place the even-numbered pages of the original in the ADF.

7Press the [Start] key.

Note

  • When making 2-sided copies, confirm which tray is used to feed paper from for making copies, by checking the [Paper Select] setting under [Copy Settings].

  • If the [Auto Clear] setting is enabled, temporary job settings may be cleared during the operation. Make sure to reconfigure the settings if they are cleared.

Reference