Connecting to the Ethernet Interface

This section describes how to connect Ethernet interface cable to the Ethernet interface.

If the main power switch is on, turn it off.
Use the following Ethernet cables.
- Unshielded Twisted Pair Cable (UTP) or Shielded Twisted Pair Cable (STP) and Category type 5 or more

Attach the supplied ferrite core at the machine end of the Ethernet interface cable.
Make sure the main power switch of the machine is off.
Connect the Ethernet interface cable to the 10BASE-T/100BASE-TX port.
Connect the other end of the Ethernet interface cable to a network connection device such as a hub.
Turn on the main power switch of the machine.
1. Indicator (green)
  Lights up green when the machine is connected correctly to the network.
2. Indicator (yellow)
  Lights up yellow when 100BASE-TX is in operation. Goes off when 10BASE-T is in operation.
- For details about how to turn on the main power switch, see "Turning On the Power", About This Machine.
- For details about installing the printer driver, see "Preparing the Machine", Printer Reference.