This section describes the machine status messages.
Message |
Status |
---|---|
“Hex Dump Mode” |
In the Hex Dump mode, the machine receives data in hexadecimal format. Turn off the machine after printing, and then turn back on. |
“Job Suspended...” |
Printing was temporarily stopped by SmartDeviceMonitor for Client. You can resume printing via [My Job List] in SmartDeviceMonitor for Client, or via the Web Image Monitor. To resume printing via Web Image Monitor, check with your system administrator first. |
“Offline” |
The machine is offline. To start printing, switch the machine online by pressing [ |
“Please wait.” |
This message might appear for a second or two while the machine is preparing, performing initial adjustments, or adding toner. Wait a while. |
“Printing...” |
The machine is printing. Wait a while. |
“Ready” |
This is the default ready message. The machine is ready for use. No action is required. |
“Resetting job...” |
The machine is resetting the print job. Wait until “Ready” appears on the display panel. |
“Setting change...” |
The machine is setting changing. You cannot use the control panel while this message is displayed. Wait a while. |
“Waiting for print data...” |
The machine is waiting for the next data to print. Wait a while. |