Skip header
ManualsContentsPreviousNextHelp

Top Page > Troubleshooting > Appendix > When Z-folded Paper Is Not Properly Aligned > Finisher SR4040

Finisher SR4040

Use the following procedure to attach the Z-fold support tray for finisher to the finisher shift tray or finisher upper tray.

  1. Remove the prints.

  2. Attach the Z-fold support tray to the finisher upper tray or finisher shift tray.

    Finisher upper tray:

    Finisher upper tray illustration

    Finisher shift tray:

    Attach the Z-fold support tray by inserting the two pegs on its underside into the two holes on the finisher shift tray.

    Finisher shift tray illustration

TopPreviousNext
Copyright (C) 2009