ManualsContentsPreviousNext |
Follow the procedure below to set the machine using the control panel when loading thick paper, thin paper or OHP transparencies onto the bypass tray.
The following procedures are not required if you select [Driver / Command] in [Bypass Tray] under [Tray Setting Priority] in [System] of [Printer Features]. In that case, set the paper size using the printer driver. For details about [System] settings, see "System".
If you select [Machine Settings] in [Bypass Tray] under [Tray Setting Priority] in [System] of [Printer Features], the settings made using the control panel have priority over the printer driver settings. For details about [System] settings, see "System".
Be sure to remove printed OHP transparencies one by one as they are output. This prevents them sticking together.
Press the [User Tools/Counter] key on the control panel.
Press [System Settings].
Press the [Tray Paper Settings] tab.
Press [Next] to scroll through the list.
Press [Paper Type: Bypass Tray].
Select the proper items, according to the paper type you want to set.
Press [OHP (Transparency)] on the [Paper Type] area when loading OHP transparencies.
Press [Do not Display] on the [Paper Type] area, and then press [Thick Paper 1], [Thick Paper 2], [Thick Paper 3], or [Thin Paper] on the [Paper Thickness] area when loading thick paper or thin paper.
Press [OK].
The paper type selected is displayed.
Press the [User Tools/Counter] key.
The initial screen appears.
Printing on special paper such as thick paper, thin paper or OHP transparencies may be slower than printing on plain paper.
The settings made will remain valid until they are reset again. After printing on OHP transparencies, thick paper or thin paper make sure to clear settings for the next user.
The bypass tray is not usable when the Wide LCT is installed. For details about [Paper Type: LCT], see "System Settings", Network and System Settings Reference.
For details about setting printer drivers, see the printer driver Help.