![]() ![]() ![]() | ![]() | ![]() | |
![]() | |||
![]() | |||
![]() | ![]() | ![]() | ![]() |
![]() | ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() | ![]() ![]() ![]() |
This section describes how to load paper into the LCT.
The LCT uses 81/2 × 11 paper exclusively. If you want to load A4
or B5 JIS
, contact your service representative.
The optional extension unit is required to load B4 JIS, A4
, 81/2 × 14
, or 81/2 × 11
into the LCT.
Align the paper neatly and press its edge to the right and left plate. Poorly loaded paper causes misfeeds.
Check the paper edges are aligned at the left side.
Open the top cover of the LCT.
Press the [Down] key.
The key blinks while the bottom plate is moving down.
Load paper into the tray along the edge on the left.
Load the paper print side up. Do not stack paper over the limit mark.
Close the top cover of the LCT.
The tray can hold up to 4,000 sheets.