![]() ![]() ![]() | ![]() | ![]() | |
![]() | |||
![]() | |||
![]() | ![]() | ![]() | ![]() |
![]() | ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() | ![]() ![]() ![]() |
This section describes how to load paper into the A3/11 × 17 tray unit.
To use the A3/11 × 17 tray unit, you must replace Tray 1.
Make sure the paper stack is flush to the right side fence.
Carefully pull out the paper tray until it stops.
Place the paper print side down along the edge on the right.
Do not stack paper over the limit mark.
Carefully slide the paper tray fully in.
The tray can hold up to 1,100 sheets of paper.