Copying onto Envelopes from the Bypass Tray

When copying onto envelopes, specify the paper type and paper size.

Before using this function, specify the paper thickness under Paper Type: Bypass Tray in User Tools. For details, see "System Settings", Network and System Settings Reference.

Open the bypass tray, and then insert the paper face up until you hear the beep.
Align the paper guides to the envelope side.
Press [Bypass], and then press the [] key.
Press [Paper Size].
Press [Custom Size].
Specify the envelope size, and then press [OK] twice.
Place the originals, and then press the [Start] key.

When placing an original on the exposure glass, place the original with the bottom line aligned to the left scale.
When placing an original in the ADF, place the original with the bottom line inserted in the ADF.
When inserting envelopes, be sure to unfold the flaps and position them opposite to the paper feed direction.
Load envelopes (162 × 229 mm (C5)) flap down, flap fold against the side guide.
When entering the horizontal size for envelopes, including the opened-out flap in the measurement.
1. Vertical size
2. Horizontal size
You can load up to 10 envelopes (80 - 95 g/m², 20 - 24 lb. Bond) in the bypass tray at the same time, without compressing them. Check the envelopes are not damp. Load only as much envelopes as can be held between the paper guides on the bypass tray.
Check there is no air in the envelopes before loading.
To get better print quality, it is recommended that you set the right, left, top, and bottom print margin, to at least 15 mm (0.6 inch) each.
You cannot print envelopes with the Duplex function.
Load only one size and type of envelope at a time.
Before loading envelopes, flatten leading edges (the side going into the machine) by pressing a pencil or ruler across them.
Before loading envelopes, check they are rectangular in shape.
For details about supported envelope types, see "Envelopes", About This Machine.