Skip header
 

Top Page > General Settings Guide > Connecting the Machine > Connecting to the Interfaces > Connecting to the Ethernet Interface

Connecting to the Ethernet Interface

This section describes how to connect Ethernet interface cable to the Ethernet interface.

Important

  • If the main power switch is on, turn it off.

  • Use the following Ethernet cables.

    • Unshielded Twisted Pair Cable (UTP) or Shielded Twisted Pair Cable (STP) and Category type 5 or more

1Attach the supplied ferrite core at the machine end of the Ethernet interface cable.

Illustration of Ethernet cable with ferrite core

2Make sure the main power switch of the machine is off.

3Connect the Ethernet interface cable to the 10BASE-T/100BASE-TX port.

Illustration of connecting the Ethernet interface cable

4Connect the other end of the Ethernet interface cable to a network connection device such as a hub.

5Turn on the main power switch of the machine.

10BASE-T/100BASE-TX port illustration (numbered callout illustration)

  1. Indicator (green)

    Lights up green when the machine is connected correctly to the network.

  2. Indicator (yellow)

    Lights up yellow when 100BASE-TX is in operation. Goes off when 10BASE-T is in operation.

Note

  • For details about how to turn on the main power switch, see "Turning On the Power", About This Machine.

  • For details about installing the printer driver, see "Preparing the Machine", Printer Reference.