Loading Paper into Tray 3 (LCT)

This section describes how to load paper into tray 3 (LCT).

Tray 3 (LCT) uses 8¹/₂ × 11 paper exclusively. Only load 8¹/₂ × 11 paper. If you want to load A4, contact your service representative.
Align the paper stacks and load them against the left and right walls, or a paper misfeed might occur.
Each tray hold up to 1,000 sheets of paper. Do not stack paper over the limit mark.

Carefully pull out tray 3 (LCT) until it stops.
With the print side up, align all four sides of two paper stacks, and then load them next to each other in the tray.
The machine cannot detect stacks of ten or fewer sheets. If the stack on the left side of the tray contains ten or fewer sheets, the machine will not detect it and not move it to the right side of the tray. Check the number of sheets remaining on the left and if there are 10 or fewer, transfer them by hand to the right side of the tray.
Carefully push the paper tray fully in.