Top Page > Troubleshooting > Remarks > Where to Put Your Machine > Power Connection

Power Connection

This section describes power supply.

Connect this machine only to a power source that matches the specifications shown on the inside front cover of this manual and do not use an extension cord.
Use of this machine with extension cords and power sources other than those that match the specifications shown constitutes an electric shock and fire hazard.

Do not use power cords that are damaged, broken, or modified. Also, do not use power cords that have been trapped under heavy objects, pulled hard, or bent severely. Doing so could result in fire or electric shock.

If the power cord is damaged and its inner wires are exposed or broken, contact your service representative for a replacement. Use of damaged power cords could result in fire or electric shock.

Be sure to locate the machine as close as possible to a wall outlet. This will allow easy disconnection of the power cord in the event of an emergency.

When you disconnect the power plug from the wall outlet, always pull the plug (not the cable).

To disconnect the power cord, pull it out by plug. Do not drag the cord itself. Doing so may result in damage to the cord, leading to fire or electric shock.

When the main power switch is in the stand-by position, the optional anti-condensation heaters are on. In an emergency, unplug the machine's power cord.
When you unplug the power cord, the anti-condensation heaters turn off.
Make sure the plug is inserted firmly in the wall outlet.
Voltage must not fluctuate by more than 10%.