Skip header
ManualsContentsPreviousNextHelp

System Menu Parameters

This section explains about parameters that can be set on the system menu.

Print Error Report

Select whether or not to print an error report when a printer error or memory error occurs.

Default: [Off]

  • On

  • Off

Auto Continue

Specify whether or not to continue printing after a system error. When you enable this setting, specify how long the printer is to display error before resuming print.

Default: [Off]

  • Off

  • Immediate

  • 1 minute

  • 5 minutes

  • 10 minutes

  • 15 minutes

Note

  • When [Auto Continue] is set to on, and a certain error occurs in the printer while printing, the job might be cancelled, or printing will not be as intended. When a job is cancelled due to error, the printer automatically begins the next job in the queue.

Memory Overflow

You can specify whether or not to print a memory overflow error report.

Default: [Do not Print]

  • Do not Print

  • Error Information

Printer Language

You can specify the printer language.

Default: [Auto]

  • Auto

  • PCL

  • PS

  • PDF

Sub Paper Size

Specify whether or not to use paper of the alternate size automatically, if paper of the specified size is not loaded. When this setting is set to off, the printer uses paper of any size loaded in the specified tray.

Default: [Auto]

  • Auto

  • Off

Default Printer Lang.

Select the printer language to use when the printer fails to detect the printer language.

Default: [PCL]

  • PCL

  • PS

  • PDF

Energy Saver

You can specify the number of minutes Energy Saver mode is applied.

Energy Saver On/Off

You can specify whether or not to switch Energy Saver.

Default: [On]

  • On

  • Off

Note

  • When the printer switches to Energy Saver mode, the Power indicator is unlit, but the Online indicator remains lit.

Energy Saver Timer

Specify the lead time needed to switch to Energy Saver mode.

Default: [1 minute]

  • 1 minute

  • 5 minutes

  • 15 minutes

  • 30 minutes

  • 45 minutes

  • 60 minutes

Print Compressed Data

Specify whether or not to print compressed data.

Default: [Off]

  • On

  • Off

Memory Usage

Select memory to be used from Font Priority or Frame Priority.

Default: [Frame Priority]

  • Font Priority

  • Frame Priority

Spool Printing

Specify whether or not to complete spooling before starting to print.

Default: [Off]

  • On

  • Off

Note

  • Spooling stores a sent print job temporarily in the printer, and then prints it.

  • This menu appears only when the optional hard disk is installed.

RAM Disk

If the optional hard disk is not installed for PDF Direct Print, select a value of 2 MB or higher.

Default: [4 MB]

  • 0 MB

  • 2 MB

  • 4 MB

  • 8 MB

  • 16 MB

Important

  • When the amount of SDRAM is small and [RAM Disk] is set to [16 MB], printing may not be possible depending on the print job and duplex printing may be canceled. If this happens, increase the amount of SDRAM, or set [RAM Disk] to [8 MB] or less.

Note

  • This menu appears only when the optional hard disk is not installed.

  • For details about the optional SDRAM module, see Hardware Guide.

Auto E-mail Notify

Specify whether or not to send an error message to a preset e-mail address when an error occurs in the printer.

Default: [On]

  • On

  • Off

Important

  • After changing the setting, turn off the power of the printer briefly, and then turn it on again.

Note

  • For information, see Web Image Monitor Help.