Skip header
ManualsContentsPreviousNextHelp

Windows 2000/XP, Windows Server 2003/2003 R2 - USB

Important

If the printer driver has already been installed, plug and play is enabled, and the icon of the printer connected to the "USB" port is added to the [Printers] window.

If the printer driver is not installed, follow the plug-and-play instructions of the printer to install it from the CD-ROM provided.

  1. Check that the power of the printer is off.

  2. Connect the printer and computer using the USB cable.

    Connect the USB cable firmly.

  3. Turn on the power of the printer.

    Found New Hardware Wizard starts, and USB Printing Support is installed automatically.

  4. In the Found New Hardware Wizard display, click [Install the software automatically [Recommended]], and then click [Next >].

    When using Windows XP or Windows Server 2003/2003 R2, click [Install from a list or specific location [Advanced]], and then click [Next>].

  5. Select the [Specify location] check box, and then click [Next >].

  6. Insert the CD-ROM into the CD-ROM drive.

    When Auto Run starts, click [Exit].

  7. Specify the location where the source files of the printer driver are stored.

    If the CD-ROM drive is D, the source files of the printer driver are stored in the following locations:

    • PCL5e

      D:\DRIVERS\PCL5E\XP_VISTA\(language)\disk1

    • PCL6

      D:\DRIVERS\PCL6\XP_VISTA\MUI\disk1

    • PostScript 3

      D:\DRIVERS\PS\XP_VISTA\(language)\disk1

    The PCL6 printer driver is installed in the language specified by your operating system.

  8. Check the printer driver location, and then click [OK].

  9. Click [Next >].

  10. Click [Finish].

    If the printer driver has already been installed, plug and play is enabled, and the icon of the printer connected to the "USB001" port is added to the [Printers] window.

Note