spoolsw
Use the "spoolsw" command to view and configure Job Spool settings.
You can only specify diprint, lpr, ipp, ftp, smb and sftp protocol.
The "spoolsw" command for configuring Job Spool settings is available only when the optional hard disk is installed.
View settings
The Job Spool setting appears.
msh> spoolsw
Job Spool setting
msh> spoolsw spool {on | off}
Specify "on" to enable Job Spool, or "off" to disable it.
Resetting Job spool setting
msh> spoolsw clear job {on | off}
When the printer power is cut during job spooling, this determines whether to reprint the spooled job.
Protocol configuration
msh> spoolsw diprint {on | off}
msh> spoolsw lpr {on | off}
msh> spoolsw ipp {on | off}
msh> spoolsw smb {on | off}
msh> spoolsw ftp {on | off}
msh> spoolsw sftp {on|off}
You can specify the settings for diprint, lpr, ipp, smb and sftp.
msh> spoolsw wsprn {on|off}
