Skip header
 

authfree

Use the "authfree" command to view and configure AuthFree parameters.

View settings

The following command displays the current AuthFree settings:

msh> authfree

  • If print job authentication exclusion is not set, authentication exclusion control cannot be displayed.

IPv4 address settings

msh> authfree "ID" range_addr1 range_addr2

IPv6 address settings

msh> authfree "ID" range6_addr1 range6_addr2

IPv6 address mask configuration

msh> authfree "ID" mask6_addr1 masklen

Parallel/USB settings

msh> authfree [parallel | usb] [on|off]

  • To enable authfree, set to on. To disable authfree, set to off. Always specify the interface.

Authentication exclusion control initialization

msh> authfree flush