OHP transparencies

Printer setup

Make the following setting using the control panel:

Select [Paper Input] [Paper Type: Bypass Tray] [OHP (Transparency)].

Printer driver setup

Click [Transparency] in the "Paper Type:" list.

Enabled paper feeding tray

This paper type can be printed only from the bypass tray.

Number of sheets that can be set

Bypass Tray: 1 sheet

Both-sided printing

Not possible

Additional cautions

• Print speed for OHP transparencies is slower than for plain paper.

• Depending on the setting made for mode switching, the printer goes into standby mode 30 or 40 seconds after receiving a job.

• We recommend you use a 4000 ANSI lumen or brighter overhead projector to project OHP transparencies.

• When printing on OHP transparencies that have a print side, load them with the print side facing up on the bypass tray.

• When printing multiple pages, remove output sheet as it comes out. Do not leave multiple sheets remaining on the output tray.