Skip header
 

Top Page > Printer Reference > Preparing the Machine > Connecting to the Interfaces > Connecting to the System Interface > Connecting to the Ethernet Interface

Connecting to the Ethernet Interface

This section describes how to connect Ethernet interface cable to the Ethernet interface.

Important

  • If the main power switch is on, turn it off.

  • Use the following Ethernet cables.

    • Unshielded Twisted Pair Cable (UTP) or Shielded Twisted Pair Cable (STP) and Category type 5 or more

1Make sure the main power is switched off.

2Connect the 100BASE-TX/10BASE-T cable to the Ethernet port.

Illustration of connecting the Ethernet interface cable

3Connect the other end of the Ethernet interface cable to a network connection device such as a hub.

4Turn on the main power switch of the printer.

10BASE-T/100BASE-TX port illustration numbered callout illustration

  1. Indicator (yellow)

    Lights up yellow when 100 BASE-TX is in operation. Goes off when 10 BASE-T is in operation.

  2. Indicator (green)

    Lights up green when 10 BASE-T is in operation. Goes off when 100 BASE-T is in operation.

Note

  • For details about how to turn on the main power switch, see "Turning On the Main Power", About This Machine.

  • For details about installing the printer driver, see "Installing the Printer Driver".

Reference