Network

The following settings are available under [Network] on the [Interface Settings] tab.

IPv4

Select whether or not to allow communication over an IPv4 network. If the setting has been changed from inactive to active, you must restart the printer to apply the new setting.

The default setting is Active (communication over IPv4 is allowed).

IPv4 Address

Specify the printer's IPv4 address.

Subnet Mask

Specify the printer's IPv4 subnet mask.

IPv4 Default Gateway Address

Specify the printer's IPv4 gateway address.

IP Address Setting Method

Specify the method by which the printer obtains its printer's IP address: automatically by DHCP (from a server), or by manual entry.

The default setting is Specify (manual entry).

This setting becomes effective after the printer has been restarted.

Transmission Speed

Specify the method and speed of transmission. This setting becomes effective after the printer has been restarted.

Select the speed that matches your network environment. We recommend you select [Auto Select] if you are unsure of your network's specifications.

The default setting is Auto Select.

	10Mbps Half Duplex	10Mbps Full Duplex	100Mbps Half Duplex	100Mbps Full Duplex	1Gbps Full Duplex	Auto Select
10Mbps Half Duplex
10Mbps Full Duplex
100Mbps Half Duplex
100Mbps Full Duplex
1Gbps Full Duplex
Auto Select

IPv6

Select whether or not to allow communication over an IPv6 network. If the setting has been changed from inactive to active, you must restart the printer to apply the new setting.

The default setting is Active (communication over IPv6 is allowed).

IPv6 Address

Select this to browse for the link local address, stateless address (max: 5), and the default gateway for the IPv6 network.

Manual Configuration Address

Specify the printer's IPv6 address.

Stateless Address Autoconfiguration

You can select whether or not to automatically select the stateless address for the IPv6 network. To change the setting from “Active” to “Inactive”, restart the printer to make the setting effective.

The default setting is Active.

HTTP Port Number

Select the port to be used to connect to Web Interface. This setting becomes effective after the printer has been restarted.

The default setting is 80.

DDNS Configuration

Enable or disable DDNS.

The default setting is Inactive (DDNS is disabled).

Domain Name

Specify the method by which the printer obtains its domain name: automatically by DNS (from a server), or by manual entry. If you select manual entry, you must enter the domain name, and then restart the printer for this name to become effective.

The default setting is Specify (manual entry).

DNS Server IPv4 Address

Specify the method by which the printer obtains the DNS server's address: automatically, or by manual entry.

The default setting is Specify (manual entry).

DNS Server IPv6 Address

You can specify the IPv6 address for the DNS server.

Host Name

Enter a host name for this printer.