Power Connection

This section describes power supply.

Connect this machine only to a power source that matches the specifications shown in “Specifications for the Main Unit” in this manual and do not use an extension cord.
Use of this machine with extension cords and power sources other than those that match the specifications shown constitutes an electric shock and fire hazard.

Power cords that are damaged, broken, modified, trapped under heavy objects, pulled hard, or bent severely are electric shock and fire hazards.

If the power cord is damaged (exposure of the core, disconnection, etc.), contact your service representative to change a new one. Operating the printer with a damaged power cord may cause an electric shock or fire.

When you disconnect the power plug from the wall outlet, always pull the plug (not the cable).

To disconnect the power cord, pull it out by plug. Do not drag the cord itself. Doing so may result in damage to the cord, leading to fire or electric shock.

Make sure the plug is inserted firmly in the wall outlet.
Voltage must not fluctuate by more than 10%.
When the trimmer is in use, voltage fluctuation must not exceed +6% to -10%. Voltage fluctuation in excess of this range can result in the trimmer malfunctioning.
The wall outlet shall be installed near the printer and shall be easily accessible.
Confirm how much power the options draw, and then plug them into an outlet that is nearby but separate from the outlet that the main unit is plugged into.