ManualsContentsPreviousNext |
This section describes how to load paper into the optional wide LCT.
The optional wide LCT is identified as Tray 4, Tray 5, and Tray 6.
Various sizes of paper can be loaded in the optional wide LCT by adjusting the positions of side fence and end fence.
Check the paper edges are aligned at the left side.
Do not stack paper over the limit mark.
When setting tab stock, always use the tab sheet holder.
When loading the optional wide LCT with paper that is 100 139.7 mm (4.0 5.5 inches) long, always use the special side fence.
Carefully pull out the paper tray until it stops.
Load paper into the paper tray by pushing it against to the left side of the paper tray.
Load the paper print side up.
Carefully push the paper tray fully in.
The tray can hold up to 1,000 sheets in Tray 4 and 6, and 2,000 sheets in Tray 5.
If you load paper that cannot be automatically detected, specify its size using the control panel.