ManualsContentsPreviousNext |
This section describes how to load paper into the optional LCT.
The optional LCT is identified as Tray 4, Tray 5, and Tray 6.
Various sizes of paper can be loaded in Tray 4 and Tray 5 by adjusting the positions of side fence and end fence.
Tray 6 uses only 81/2 × 11 paper. If you want to load A5, B5 JIS, A4, or 51/2 × 81/2, contact your service representative.
Check the paper edges are aligned at the left side.
Do not stack paper over the limit mark.
When setting tab stock, always use the tab sheet holder.
Tab stock can be loaded only in Tray 4 and Tray 5.
Carefully pull out the paper tray until it stops.
Load paper into the paper tray by pushing it against to the left side of the paper tray.
Load the paper print side up.
Carefully push the paper tray fully in.
The tray can hold up to 1,000 sheets in Tray 4 and Tray 5, and 2,550 sheets in Tray 6.