Log on to Web Image Monitor in the administrator mode.
Click [Configuration].
Select [IEEE 802.1X (WPA/WPA2)] in “Security” area.
In “User Name”, enter the user name set in the RADIUS server.
Enter the domain name in “Domain Name”.
Select “EAP Type”. Configurations differ according to the EAP Type.
EAP-TLS
Make the following settings according to the operating system you are using:
Select [On] or [Off] in “Authenticate Server Certificate”.
Select [On] or [Off] in “Trust Intermediate Certificate Authority”.
Enter the host name of the RADIUS server on “Server ID”.
LEAP
Click [Change] in “Password”, and then enter the password set in the RADIUS server.
EAP-TTLS
Click [Change] in “Password”, and then enter the password set in the RADIUS server.
Click [Change] in “Phase 2 User Name”, and then enter the user name set in the RADIUS server.
Select [CHAP], [MSCHAP], [MSCHAPv2], [PAP], or [MD5] in “Phase 2 Method”.
Certain methods might not be available, depending on the RADIUS server you want to use.
Make the following settings according to the operating system you are using:
Select [On] or [Off] in “Authenticate Server Certificate”.
Select [On] or [Off] in “Trust Intermediate Certificate Authority”.
Enter the host name of the RADIUS server in “Server ID”.
PEAP
Click [Change] in “Password”, and then enter the password set in the RADIUS server.
Click [Change] on “Phase 2 User Name”, and then enter the user name set in the RADIUS server.
Select [MSCHAPv2] or [TLS] in “Phase 2 Method”.
When you select [TLS], you must install “IEEE 802.1X Client Certificate”.
Make the following settings according to the operating system you are using:
Select [On] or [Off] in “Authenticate Server Certificate”.
Select [On] or [Off] in “Trust Intermediate Certificate Authority”.
Enter the host name of the RADIUS server on “Server ID”.
Click [OK].
Click [Configuration], and then click [Interface Settings] in the “Interface” area.
Select [Active] in “Ethernet Security”.
Click [OK].
Click [Logout].
Quit the Web Image Monitor.
If there is a problem with settings, you might not be able to communicate with the printer. To identify the problem, print a network summary.
If you cannot identify the problem, reset the printer interface to normal, and then repeat the procedure from the beginning.