Skip header
 

Top Page > Network and System Settings Guide > Connecting the Machine > Connecting to the Interfaces > Connecting to the Ethernet Interface

Connecting to the Ethernet Interface

This section describes how to connect Ethernet interface cable to the Ethernet interface.

Important

  • If the main power switch is on, turn it off.

  • Use the following Ethernet cables.

    • Unshielded Twisted Pair Cable (UTP) or Shielded Twisted Pair Cable (STP) and Category type 5 or more

1Make sure the main power switch of the machine is off.

2Connect the Ethernet interface cable to the 10BASE-T/100BASE-TX port.

illustration of connecting the Ethernet interface cable

3Connect the other end of the Ethernet interface cable to a network connection device such as a hub.

4Turn on the main power switch of the machine.

10BASE-T/100BASE-TX port illustration (numbered callout illustration)

  1. Indicator (green)

    Lights up green when the machine is connected correctly to the network.

  2. Indicator (yellow)

    Lights up yellow when 100 BASE-TX is in operation. Goes off when 10 BASE-T is in operation.

Note

  • For details about how to turn on the main power switch, see "Turning On the Main Power", About This Machine.

  • For details about installing the printer driver, see "Preparing the Machine", Printer Reference.