Skip header
 

Top Page > About This Machine > Adding Paper > Loading Paper > Loading Paper into the Large Capacity Tray

Loading Paper into the Large Capacity Tray

This section describes how to load paper into the LCT.

Important

  • The LCT is identified as Tray 4, Tray 5, and Tray 6.

  • Various sizes of paper can be loaded in Tray 4 and Tray 5 by adjusting the positions of side fence and end fence.

  • Tray 6 uses 81/2 × 11Portrait paper. If you want to load A5PortraitLandscape, B5 JISPortrait, A4Portrait, 51/2 × 81/2PortraitLandscape, contact your service representative.

  • Check the paper edges are aligned at the left side.

  • Do not stack paper over the limit mark.

  • When setting tab stock, always use the tab sheet holder.

    LCT illustration

  • Tab stock can be loaded only in Tray 4 and Tray 5.

1Carefully pull out the paper tray until it stops.

LCT illustration

2Load paper into the paper tray by pushing it against to the left side of the paper tray.

Load the paper print side up.

LCT illustration

3Carefully push the paper tray fully in.

Note

  • The tray can hold up to 1,000 sheets in Tray 4 and Tray 5, and 2,550 sheets in Tray 6.