Skip headerimage
ManualsContentsPreviousNextHelp

Stamp Text

This section describes the user tools in the Stamp Text menu under Stamp.

Font

You can select the font in stamp text mode.

The default setting is Font 1.

The main machine applies the settings that have been made on it. Sub-machines also apply the settings made on the main machine, regardless of the settings made on them.

Size

You can set the stamp text size.

The default setting is Auto.

The main machine applies the settings that have been made on it. Sub-machines also apply the settings made on the main machine, regardless of the settings made on them.

Superimpose

You can have the stamp text printed in white when it overlaps black parts of the image.

The default setting is Off.

The main machine applies the settings that have been made on it. Sub-machines also apply the settings made on the main machine, regardless of the settings made on them.

Stamp Setting

Specify how stamp text is printed.

  • Stamp Position

    Specify where to print the Stamp Text.

    The default setting is Top Right.

  • Adjust Stamp Position

    You can adjust the print position of the Stamp Text within the available ranges as shown below.

    • Metric version:

      "Top Left"-T/B: 4hyphen144mm, L/R: 4hyphen144mm

      "Top Center"-T/B: 4hyphen144mm, L/R: 72hyphen72mm

      "Top Right"-T/B: 4hyphen144mm, L/R: 4hyphen144mm

      "Bottom Left"-T/B: 4hyphen144mm, L/R: 4hyphen144mm

      "Bottom Center"-T/B: 4hyphen144mm, L/R: 72hyphen72mm

      "Bottom Right"-T/B: 4hyphen144mm, L/R: 4hyphen144mm

    • Inch version:

      "Top Left"-T/B: 0.1hyphen5.7 inches, L/R: 0.1hyphen5.7 inches

      "Top Center"-T/B: 0.1hyphen5.7 inches, L/R: 2.8hyphen2.8 inches

      "Top Right"-T/B: 0.1hyphen5.7 inches, L/R: 0.1hyphen5.7 inches

      "Bottom Left"-T/B: 0.1hyphen5.7 inches, L/R: 0.1hyphen5.7 inches

      "Bottom Center"-T/B: 0.1hyphen5.7 inches, L/R: 2.8hyphen2.8 inches

      "Bottom Right"-T/B: 0.1hyphen5.7 inches, L/R: 0.1hyphen5.7 inches

  • Page to Stamp

    Sets whether to print the stamp on all pages or only the first page.

    The default setting is All Pages.

  • Adj. Back Side Stamp Position

    You can adjust the stamp position for back side in duplex mode, within the available range as shown below.

    • Metric version:

      Left-Right: Left 432 mmhyphenRight 432 mm

      Top-Bottom: Top 432 mmhyphenBottom 432 mm

    • Inch version:

      Left-Right: Left 17.0 incheshyphenRight 17.0 inches

      Top-Bottom: Top 17.0 incheshyphenBottom 17.0 inches

The main machine applies the settings that have been made on it. Sub-machines also apply the settings made on the main machine, regardless of the settings made on them.