Skip header
 

Using Job Preset in Connect Copy

You can make settings for the next Connect Copy job when the current job is still in progress on the main machine.

When the current job finishes, the next job begins automatically.

1On the main machine, confirm that “Press [New Job] to make reservation.” is displayed, and then press [New Job].

Operation panel screen illustration

2Confirm that “Ready” is displayed, and then press [Connect Copy].

3Place the originals in the main machine.

4Confirm that “Ready” is displayed, and then make settings for the job.

Operation panel screen illustration

5Press the [Start] key on the main machine.

Scanning begins. As soon as the current job is finished, the next job starts automatically.

Note

  • You can preset a maximum of ten jobs.

  • When placing originals on the exposure glass, press the [Sharp] key after all originals have been scanned.

  • When placing multiple originals in the ADF, wait till the first original sets have been fed before placing the next.

  • Preset jobs in Connect Copy mode can only be changed when the main machine has finished scanning the originals.

  • Preset jobs in Connect Copy mode can only be changed when copying has yet to begin on either machine.