Skip header
 

Creep Adjustment

When Magazine is selected, you can specify the creep value.

When folding stacked paper, the thickness of the paper causes creep (progressive image loss) between the most inner and most outer pages. The machine compensates for creep by progressively shifting the copy image.

For example, when folding 15 sheets, the creep value will be 2 mm (0.1 inch), meaning there will be a 2 mm (0.1 inch) gap in the center of the image printed on the outermost sheet.

1Press [Dup./Combine/Series].

Operation panel screen illustration

2Press [Book].

3Select [1 Sided] or [2 Sided] for the original.

4Press [Magazine].

5Press [Creep Adjust.].

6Specify the creep value with [Plus] and [Minus].

Operation panel screen illustration

7Press [OK] twice.

Note

  • You can adjust the creep value between 0 to 99 mm (0 to 3.9 inches) in 1 mm (0.1 inch) steps.

  • To change the value you entered, press [Plus] and [Minus], and then specify a new value.