Skip header
 

Registering the user stamp

Scans an image that is used as a user stamp.

The range of stamp images is 10 - 297 mm (0.4 - 11.7 inches) high and 10 - 432 mm (0.4 - 17.0 inches) wide. However, if the value exceeds the maximum value of the area (5,000 mm2, 7.75 inch2), it is corrected within the range of the area automatically.

Up to four frequently used images can be stored in memory.

Illustration of User Stamp

  1. Base point

  2. Exposure glass

1Press the [User Tools] key.

User Tools key illustration

2Press [Copier / Document Server Features].

Operation panel screen illustration

3Press [Stamp].

4Press [User Stamp].

5Press [Program / Delete Stamp].

6Press [Program], and then press the stamp number you want to program.

7Enter the user stamp name (up to ten characters) with the letter keys, and then press [OK].

8Enter the horizontal size of the stamp with the number keys, and then press [Sharp].

9Enter the vertical size of the stamp with the number keys, and then press [Sharp].

10Place the original for user stamp on the exposure glass, and then press [Start Scanning].

The original will be scanned, and the stamp will be registered.

11Press [Exit].

12Press [Exit].

The display returns to the User Tools/Inquiry screen.

13Press [Exit].

Exits settings and gets ready to copy.

Note

  • Stamp numbers with already have settings in them. Stamp numbers that are not registered yet are marked with “Not Programmed”.

  • If the stamp number is already being used, the machine will ask you if you want to overwrite it. Press [Yes] or [Stop].

  • You cannot restore the overwritten stamp.

  • Originals cannot be scanned from the ADF when programming the user stamp.

  • For details about how to enter text, see “Entering Text”, About This MachineIllustration indicating book format instructionsIllustration indicating instructions stored on a CD-ROM.