Skip header
ManualsContentsPreviousNextHelp

Connecting to the Gigabit Ethernet Interface

This section describes how to connect the Ethernet interface cable to the Gigabit Ethernet port.

Important

  1. A ferrite core for the Ethernet interface cable is supplied with this machine. Make a loop in the cable about 5 cm (2.1 inch) (1) from the machine end of the cable. Attach the ferrite core.

    illustration of Ethernet cable with ferrite core

  2. Make sure the main power switch of the machine is off.

  3. Connect the Ethernet interface cable to the Gigabit Ethernet port.

    illustration of connecting Ethernet cable

  4. Connect the other end of the Ethernet interface cable to a network connection device such as a hub.

  5. Turn on the main power switch of the machine.

    Gigabit Ethernet port illustration (numbered callout illustration)

    1. Indicator (green)

      When 10BASE-T is operating, the LED is lit green. When 100BASE-TX is operating it is turned off.

    2. Indicator (yellow)

      When 100BASE-TX is operating, the LED is lit yellow. When 10BASE-T is operating, it is turned off.

    3. Indicators (both green and yellow)

      When 1000BASE-T is operating, both LED are lit.

Note