Skip headerimage
ManualsContentsPreviousNextHelp

Erase Inside

Use this function to copy the original while erasing a specified area.

Illustration of Erase Inside

To specify the area you want to erase, you have to define the value of X1, Y1, X2, and Y2 on the original. Measure the area you want to specify before entering the area settings.

Illustration of Erase Inside

X1, X2: 0 - 432 mm (0 - 17 inches)

Y1, Y2: 0 - 432 mm (0 - 17 inches)

  1. Press [Edit].

    Operation panel screen illustration

  2. Press [Erase].

  3. Select one of the areas from [Erase Inside 1] to [Erase Inside 5].

  4. Enter the length of [X1] with the number keys, and then press [Sharp].

    Operation panel screen illustration

  5. Enter the length of [Y1] with the number keys, and then press [Sharp].

  6. Enter the length of [X2] with the number keys, and then press [Sharp].

  7. Enter the length of [Y2] with the number keys, and then press [Sharp].

    If you want to erase the image on the back side of the original, press [2 Sided Setting] and then [Back].

    Erasing the image on the back side is valid when you copy 2-Sided originals.

  8. Press [OK].

  9. To specify multiple areas, select areas 1 to 5, and then repeat steps 3 to 8.

  10. Press [OK].

Note