Using the trimmer to cut the fore edge

Use this function to cut the fore edge of a document after it is saddle stitched.

This function is available only when you select Centre as the stapling position.

Select Centre as the staple position.
Press [Output/Customize Function/Finisher].
Press [Fore Edge Cut].
Specify the cut length width with [] and [], and then press [OK].
To change the value you entered, press [Clear] and then enter a new value.
Press [OK].
Enter the number of copy sets using the number keys.
Place the originals, and then press the [Start] key.

You can adjust the position of the fore edge cut from 2.0 to 20.0 mm (0.08 to 0.79 inches) in 0.1 mm (0.01 inch) increments.
Empty the trimmer tray if prints are ejected with waste paper stuck to them. For details, see Removing Waste Paper, Troubleshooting.