Skip headerGelSprinter GX e2600/GX e3300N/GX e3350N
ContentsPreviousNextHelp

Top Page > Maintaining > Performing Maintenance using the Control Panel (Maintenance Menu) > De-condensation

De-condensation

If the "ERR (993) Power Off On / Call Service if error reoccurs" message appears, there might be condensation inside the printer. You can dry the printer's interior by performing the de-condensation procedure.

  1. Press the [Menu] key.

    Menu key illustration

  2. Press the [Up arrow key] or [Down arrow key] key to display [Maintenance], and then press the [#Enter] key.

    Menu:               
     Maintenance        

  3. Press the [Up arrow key] or [Down arrow key] key to display [De-condensation], and then press the [#Enter] key.

    Maintenance:        
     De-condensation    

    Three sheets are fed through the printer without anything being printed on them.

  4. Switch the printer off and then back on again.

    Power key illustration

    If the error message does not reappear, the printer's interior has fully dried.

    If the error persists, switch the printer off, leave it for an hour, and switch it back on. If this does not solve the problem, contact your sales or service representative.

Note

Reference

TopPreviousNext
Copyright (C) 2008,2009