Skip header
Screen reader supported pageStandard
 

Top Page > Monitoring and Configuring the Printer > Using SmartDeviceMonitor for Client > Using Notification via SmartDeviceMonitor for Client > Specifying the Print Server

Specifying the Print Server

Follow the procedure below to make the settings on the print server.

Important

  • To change the print server setting, you must have access to "Printer Management access authentication". To make this possible, log on as a member of the Administrators or Power Users group.

1On the [Start] menu, point to [All Programs], point to [DeskTopBinder], [SmartDeviceMonitor for Client], and then click [Print Server Setting].

The Print Server Setting dialog box appears.

2Select the [Notify client PCs of printout/data-transmission] check box, and then click [OK].

Depending on the print server setting, a dialog box appears. Read the message in the dialog box, and then click [OK].

By clicking [Cancel], the changed setting is cancelled.

3A dialog box about specifying the client computer setting appears. Click [OK].

The print server setting has been changed. However, you still need to specify the Notification setting on each client computer.

Note

  • When the spooler stops, the print job in progress is completely reprinted.

  • If [Extended Features] was not used, it is automatically enabled.