Skip header
Screen reader supported pageStandard
 

Top Page > Preparing for Printing > Installing the Drivers for Network Connection > Installing the PCL or RPCS Raster Printer Driver (Network) > Using the Standard TCP/IP Port

Using the Standard TCP/IP Port

This section explains how to install the printer driver (TCP/IP) and set up the Standard TCP/IP Port.

Important

  • Only administrators can perform this installation. Log on as a member of the Administrators group.

1Start Windows, and then insert the provided CD-ROM into the CD-ROM drive.

Quit all applications currently running.

2Select an interface language, and then click [OK].

3Click [Printer Driver].

If your model is the GX e3350N, click [PCL/RPCS Raster Printer Drivers].

The software license agreement appears in the [<License Agreement>] dialog box.

4Read the entire license agreement carefully. If you accept its terms, click [I accept the agreement.], and then click [Next >].

5Click [Connected via LAN].

6Double-click the printer name or click [+] to display the printer settings.

The details shown in [Comment:], [Driver:], and [Port:] vary depending on the operating system, printer model, and port.

7Click [Port:], and then click [Add].

8Click [Standard TCP/IP], and then click [OK].

Configure the Standard TCP/IP port settings, and then see Windows Help if [Standard TCP/IP Port] does not appear.

9Click [Next >] in the [Add Standard TCP/IP Printer Port Wizard] dialog box.

10Enter the printer name or IP address in the [Printer Name or IP Address] box.

The [Port Name] text box automatically obtains a port name. Change this name if necessary.

When screen for Device selection appears, select "RICOH Network Printer C model".

11Click [Finish] in the [Add Standard TCP/IP Printer Port Wizard] dialog box.

The installation start dialog box reappears.

12Check that the port of the selected printer is displayed in [Port:].

13Configure the default printer as necessary.

14Click [Continue].

The printer driver installation starts.

15Select whether or not to open the Status monitor automatically.

16Click [Next >].

17Click [Finish] in the installation completion dialog box.

A message about restarting the computer may appear. Restart the computer to complete installation.

Note

  • If the message "Digital Signature Not Found" or the [Software Installation], [Hardware Installation] or [Windows can't verify the publisher of this driver software] dialog box appears:

    • Click [Yes], [Continue Anyway] or [Install this driver software anyway] to continue the installation.

  • A message about restarting the computer may appear. Restart the computer to complete installation.

Reference

  • A message appears if there is a newer version of the printer driver already installed. If there is, you cannot install the printer driver using Auto Run. If you still want to install the printer driver, use [Add Printer]. See If a Message Appears during Installation.