Skip header
 

If You Cannot Exit from Connect Copy

This section describes causes and remedies if you cannot exit from Connect Copy.

Problem

Cause

Solution

There is no response when you press [Connect Copy].

Scanning is in progress.

Press the [Clear/Stop] key on the main machine, and then press [Stop].

There is no response when you press [Connect Copy].

Copying is in progress.

Press the [Clear/Stop] key on the main machine, and then press [Stop].

There is no response when you press [Connect Copy].

A paper misfeed has occurred on either the main machine or sub-machine.

  • Follow the instructions displayed. For details, see Removing Jammed Paper and Removing Jammed Staples.

  • If the sub-machine's display indicates that a cover is open, follow the instructions displayed.

  • To cancel Connect Copy, Press the [Clear/Stop] key on the main machine, and then press [Stop].

There is no response when you press [Connect Copy].

The [Clear/Stop] key has been pressed on the main machine.

To cancel Connect Copy, Press the [Clear/Stop] key on the main machine, and then press [Stop].

There is no response when you press [Connect Copy].

Toner or other supplies need to be replaced on either the main machine or sub-machine.

  • Follow the instructions displayed. For details about loading paper or adding toner and staples, see "Loading Paper", "Adding Toner", and "Adding Staples", About This MachineIllustration indicating instructions stored on a CD-ROMIllustration indicating instructions stored on a CD-ROM. For details about removing punch and staple waste, see Removing Punch Waste and Removing Staple Waste.

  • To cancel Connect Copy, Press the [Clear/Stop] key on the main machine, and then press [Stop].