Skip headerimage
ManualsContentsPreviousNextHelp

Stapling precautions

Paper size and staple capacity

Finisher SR4050

Paper Size

Staple Capacity

A3Landscape, B4 JISLandscape, 11×17Landscape, 81/2×14Landscape, 81/4×13Landscape, 8×13Landscape, 71/4×101/2PortraitLandscape, 8KLandscape, 16KPortraitLandscape, 11×14Landscape

50

A4PortraitLandscape, B5 JISPortraitLandscape, 81/2×11PortraitLandscape

100

Finisher SR4030/ Finisher SR4040

Paper Size

Staple Capacity

A3Landscape, B4 JISLandscape, 11×17Landscape, 81/2×14Landscape, 8×13Landscape, 81/2×13Landscape, 81/4×13Landscape, 8KLandscape, 11×14Landscape

30

A4PortraitLandscape, B5 JISPortraitLandscape, 81/2×11PortraitLandscape, 71/4×101/2PortraitLandscape, 16KPortraitLandscape

50

Staple capacity for booklet staple

With Finisher SR4040 installed, booklet stapling is available.

Paper Size

Staple Capacity

A3Landscape, A4Landscape, B4 JISLandscape, B5 JISLandscape, 11×17Landscape, 81/2×14Landscape, 81/2×11Landscape

15

Mixed Size

You can mix two different paper sizes to staple if the width of the paper is the same.

Booklet stapling is unavailable for mixed size paper.

Mixed Paper Size

Staple Capacity for Finisher SR4050

Staple Capacity for Finisher SR4030/ Finisher SR4040

A3Landscape and A4Portrait

50

30

B4 JISLandscape and B5 JISPortrait

50

30

11×17Landscape and 81/2×11Portrait

50

30

Conditions where stapling will be canceled.

Collate will continue if it was specified along with the staple function.

  • If paper sizes which can not mix together are contained in a single job.

  • If the number of pages to staple exceeds the maximum.

  • If a paper size that cannot be stapled is selected.

  • If a paper type that cannot be stapled is selected.

  • When the setting does not meet collating requirements.

  • When the record area for collate overflows during the job.

  • If positions other than those fixed for stapling are specified.

  • If there are inconsistencies between the orientation in duplex mode and the staple position.

  • If there are inconsistencies between the orientation in letterhead mode and the staple position.

  • When paper is loaded using the bypass tray.

  • If the size of the paper after it is Z-folded is not supported for stapling.

  • When only 1 page is printed (only when booklet staple is specified with Finisher SR 4040).

Note

Reference