Skip header
 

Setting Items of IEEE 802.1X for Ethernet

1Log on to Web Image Monitor in the administrator mode.

2Click [Configuration].

3Select [IEEE 802.1X (WPA/WPA2)] in “Security” area.

4In “User Name”, enter the user name set in the RADIUS server.

5Enter the domain name in “Domain Name”.

6Select “EAP Type”. Configurations differ according to the EAP Type.

EAP-TLS

  • Make the following settings according to the operating system you are using:

    • Select [On] or [Off] in “Authenticate Server Certificate”.

    • Select [On] or [Off] in “Trust Intermediate Certificate Authority”.

    • Enter the host name of the RADIUS server on “Server ID”.

LEAP

  • Click Change in “Password”, and then enter the password set in the RADIUS server.

EAP-TTLS

  • Click [Change] in “Password”, and then enter the password set in the RADIUS server.

  • Click [Change] in “Phase 2 User Name”, and then enter the user name set in the RADIUS server.

  • Select [CHAP], [MSCHAP], [MSCHAPv2], [PAP], or [MD5] in “Phase 2 Method”.

  • Certain methods might not be available, depending on the RADIUS server you want to use.

  • Make the following settings according to the operating system you are using:

    • Select [On] or [Off] in “Authenticate Server Certificate”.

    • Select [On] or [Off] in “Trust Intermediate Certificate Authority”.

    • Enter the host name of the RADIUS server in “Server ID”.

PEAP

  • Click [Change] in “Password”, and then enter the password set in the RADIUS server.

  • Click [Change] on “Phase 2 User Name”, and then enter the user name set in the RADIUS server.

  • Select [MSCHAPv2] or [TLS] in “Phase 2 Method”.

  • When you select [TLS], you must install “IEEE 802.1X Client Certificate”.

  • Make the following settings according to the operating system you are using:

    • Select [On] or [Off] in “Authenticate Server Certificate”.

    • Select [On] or [Off] in “Trust Intermediate Certificate Authority”.

    • Enter the host name of the RADIUS server on “Server ID”.

7Click [OK].

8Click [Configuration], and then click [Interface Settings] in the “Interface” area.

9Select [Active] in “Ethernet Security”.

10Click [OK].

11Click [Logout].

12Quit the Web Image Monitor.

Note

  • If there is a problem with settings, you might not be able to communicate with the printer. To identify the problem, print a network summary.

  • If you cannot identify the problem, reset the printer interface to normal, and then repeat the procedure from the beginning.