Skip header
 

Top Page > Software Guide > Special Operations under Windows > Printing Files Directly from Windows > Setup

Setup

Use the following procedure to make network environment settings.

1Enable TCP/IP using the control panel, and then set up the printer's network environment about TCP/IP including IP addresses.

TCP/IP of the printer is set as default.

2Install a TCP/IP in Windows to set up the network environment.

Consult the network administrator for the local setting information.

3To print, install “Printing service for UNIX” as the network application.

Reference

  • For details about setting up IPv4 address, see Hardware Guide.

  • For details about setting the IPv4 address of the printer using DHCP, see Using DHCP.

  • This completes the setup for specifying a printer using an IPv4 address when printing. When using a host name to specify a printer, proceed to Using a Host Name Instead of an IPv4 Address and continue the setup.