Host Interface Menu Parameters
This section explains parameters that can be set on the Host Interface menu.
USB Timeout
You can specify how many seconds the printer should wait before ending a print job that is receiving via USB. If printing is frequently interrupted by data from other ports, increase the timeout period.
Default: 60 seconds
15 seconds
60 seconds
300 seconds
Network Timeout
You can specify how many seconds the printer should wait before ending a print job that is receiving via Ethernet. If printing operation is frequently interrupted by data from other ports, you can increase the timeout period.
Default: 60 seconds
15 seconds
60 seconds
300 seconds
Network Setup
You can make network-related settings.
DHCP
Select whether to set the IPv4 address automatically or manually.
Default: On
On
Off
After changing the setting, turn off the power of the printer briefly, and then turn it on again.
MAC Address
Check the MAC address.
IP Address
Specify the IPv4 address.
When [DHCP] is set to [On], the IP address cannot be changed.
To change it, set [DHCP] to [Off].
Contact your network administrator for information about the network configuration.
Default: 192.0.0.192
Subnet Mask
Specify the subnet mask.
When [DHCP] is set to [On], the subnet mask cannot be changed.
To change it, set [DHCP] to [Off]. Contact your network administrator for information about the network configuration.
Default: 255.255.255.0
Gateway Address
Specify the gateway address.
When [DHCP] is set to [On], the gateway address cannot be changed.
To change it, set [DHCP] to [Off].
Contact your network administrator for information about the network configuration.
Default: 192.0.0.192
Frame Type (NW)
Default: Auto Select
Auto Select
Ethernet ll
Ethernet 802.2
Ethernet 802.3
Ethernet SNAP
Active Protocol
Select active protocols.
TCP/IP
Default: Active
Active, Not Active
NetWare
Default: Active
Active, Not Active
AppleTalk
Default: Active
Active, Not Active
Ethernet Speed
Select the network speed to operate the printer.
Default: Auto Select
Auto Select
10Mbps Half D.
10Mbps Full D.
100Mbps Half D.
100Mbps Full D.
USB Speed
You can make setting for USB Host interface.
Default: Auto Select
Full Speed
Auto Select
After changing the setting, turn off the power of the printer briefly, and then turn it on again.
This function is only available for the SP C232DN model printer.
