Setting the Ethernet Speed

You can set the speed that the printer will use for Ethernet communication. For normal usage, the default setting [Auto Select] is suitable and does not need to be changed. This setting allows two connected interfaces to automatically determine the optimum speed that they will communicate at.

Router/HUB	Printer
Router/HUB	[10Mbps Half D.]	[10Mbps Full D.]	[100Mbps Half D.]	[100Mbps Full D.]	[Auto Select]
10Mbps Half Duplex		-	-	-
10Mbps Full Duplex	-		-	-	-
100Mbps Half Duplex	-	-		-
100Mbps Full Duplex	-	-	-		-
auto-negotiation (auto selection)		-		-

Connection cannot be established if the selected Ethernet speed does not match your network's transmission speed.
The use of this feature is recommended. To use it, select [Auto Select].

Press the [Menu] key.
Press the [] or [] key to display [Host Interface], and then press the [#Enter] key.

Menu: Host Interface
Press the [] or [] key to display [Network Setup], and then press the [#Enter] key.

Host Interface: Network Setup
Press the [] or [] key to display [Ethernet Speed], and then press the [#Enter] key.

Network Setup: Ethernet Speed
Press the [] or [] key to select the Ethernet speed, and then press the [#Enter] key.
Press the [Menu] key.
The initial screen appears.
Print a configuration page to confirm the settings made.
- For details about printing the configuration page using control panel, see Test Printing.