Skip header
 

Top Page > Hardware Guide > Cleaning the Printer > Cautions to Take When Cleaning

Cautions to Take When Cleaning

WARNING

  • Do not attempt any maintenance or troubleshooting other than that mentioned in this manual. This machine contains a laser beam generator and direct exposure to laser beams can cause permanent eye damage.

CAUTION

  • The inside of this printer becomes very hot. Do not touch parts labelled “” (indicating a hot surface).

Clean the printer periodically to maintain fine printing.

Dry wipe the exterior with a soft cloth. If dry wiping is not enough, wipe with a soft, wet cloth that is wrung out well. If you still cannot remove the stain or grime, use a neutral detergent, and then wipe over with a well-wrung wet cloth, dry wipe, and let it dry.

Important

  • To avoid deformation, discoloration, or cracking, do not use volatile chemicals, such as benzine and thinner, or spray insecticide on the printer.

  • If there is dust or grime inside the printer, wipe with a clean, dry cloth.

  • You must disconnect the plug from the wall outlet at least once a year. Clean away any dust and grime from the plug and outlet before reconnecting. Accumulated dust and grime pose a fire hazard.

  • Do not allow paper clips, staples, or other small metallic objects to fall inside the machine.