Skip header
 

Loading Paper in the Bypass Tray

Important

  • Set the size of the loaded paper using the control panel or the printer driver. Make sure the settings do not conflict. Otherwise, the paper may jam or the print quality may be affected.

  • Load paper with the print side down and in the short-edge feed direction.

  • Duplex printing is not possible.

  • You cannot use the bypass tray to feed in paper that requires a specified printing position (such as preprinted paper). Use tray 1 for such paper.

  • If paper is curled, straighten it before loading, by bending it the paper in the opposite direction to the curl, for example.

  • Do not load paper while the machine is printing.

  • Tray 1 and 2 are unavailable while paper is being loaded in the bypass tray.

  • You cannot load paper into the bypass tray while the machine is in Energy Saver mode. If the machine is in Energy Saver mode, press the [Copy] key to recover from Energy Saver mode.

1Insert the top edge of the paper into the machine.

image

2Adjust the paper guides to the paper size.

image

3Support the paper with both hands, and insert it carefully until it stops.

image

4Start printing.

Note

  • After loading paper in the tray, specify the paper type and size using the control panel or the printer driver.

Reference