Enabling WSD using Web Image Monitor

To use this machine as a WSD scanner, you must first configure the following settings using Web Image Monitor on a client computer:

Settings for WSD (Push Type) and WSD (Pull Type)
- WSD protocol (default setting: [Active])
  Click [Configuration], click [IPv4] or [IPv6] under [Network], and then enable [WSD (Scanner)].
Settings to enable WSD (Push Type)
- [Display WSD Destination List] (default setting: [Do not Display])
  Click [Configuration], click [Administrator Tools] under [Scanner], and then set [Display WSD Destination List] to [Display].
Settings to enable WSD (Pull Type)
- [Prohibit WSD Scan Command] (default setting: [Prohibit])
  Click [Configuration], click [Administrator Tools] under [Scanner], and then set [Prohibit WSD Scan Command] to [Do not Prohibit].

Use the following procedure to enable both WSD (Push Type) and WSD (Pull Type).

On the [Start] menu, click [Network].
Double-click the icon for this machine.
The Web Image Monitor login page appears.
Click [Login].
Enter your login user name and password in the [Login User Name] and [Login Password] boxes respectively, and then click [Login].
Consult your administrator if you require a login user name and password.
On the menu in the left frame, click [Configuration].
Under [Scanner], click [Administrator Tools].
The [Administrator Tools] page appears.
Set [Display WSD Destination List] to [Display].
Set [Prohibit WSD Scan Command] to [Do not Prohibit].
Click [OK].

For details about displaying Web Image Monitor, see "Monitoring and Configuring the Printer", Network and System Settings Guide. For details about using Web Image Monitor, see Web Image Monitor Help.