Skip headerimage
ManualsContentsPreviousNextHelp

Top Page > Network and Syetem Settings Guide > Monitoring and Configuring the Printer > Remote Maintenance by telnet > autonet

autonet

Use the "autonet" command to configure AutoNet parameters.

View settings

The following command displays the current AutoNet settings:

msh> autonet

Configuration

You can configure AutoNet settings.

msh> autonet {on|off}

  • {on} means "active" and {off} means "inactive".

Current interface priority configuration display

msh> autonet priority

Interface priority configuration

msh> autonet priority "interface_name"

  • You can give interface's AutoNet parameter priority.

  • Priority settings are available when multiple interfaces are installed.

  • wlan can be specified only when the IEEE 802.11 interface is installed.

Interface

Interface configured

ether

Ethernet interface

wlan

IEEE 802.11 interface

Note

  • If an interface is not selected, the current interface connection settings remain in effect.

  • For details about AutoNet, refer to autonet parameters.

TopPreviousNext
Copyright (C) 2008