Programming an End Receiver

One end receiver can be registered for each special sender. To register two or more end receivers, use group destination. Up to 100 destinations can be specified in a group. However, when adding a group to another group, a maximum of 150 destinations can be specified in a group.

Select [Fax Features] using [] or [], and then press the [OK] key.
Select [Administrator Tools] using [] or [], and then press the [OK] key.
Select [Forwarding] using [] or [], and then press the [OK] key.
Select [On] using [] or [], and then press the [OK] key.
To cancel forwarding, press [Off] and proceed to step 6.
Search and select a receiver using the Quick Dial keys, and then press the [OK] key.
Pressing switches the destination.
If you make a mistake, press the [Clear/Stop] key, and then enter again.
Press the [User Tools/Counter] key.

In Step 5, you can search for and specify the forwarding destination by pressing the Search Destination key or a User Function key. To specify a forwarding destination by pressing a User Function key, you must first register the [Specify Dest. Reg. No.] function as a User Function key. For details about the User Function keys, see "General Settings/Adjust".
For details about how to register folders, see "Registering Folders", Network and System Settings Guide.