Skip headerimage
ManualsContentsPreviousNextHelp

Top Page > Hardware Guide > Troubleshooting > Removing Jammed Staples > When the Booklet Finisher is Installed

When the Booklet Finisher is Installed

  1. Open the front cover of the finisher.

    Booklet finisher illustration

  2. Holding the R7 lever, pull out the staple unit.

    Staple illustration

  3. Raise the lever.

    Staple illustration

  4. Holding the lever on the cartridge, pull the cartridge gently out of the staple unit.

    Staple illustration

  5. Raise the face plate of the cartridge.

    Staple illustration

  6. Remove the jammed staples.

    Staple illustration

  7. Push the face plate down until it clicks.

    Staple illustration

  8. Holding the lever on the cartridge, push the cartridge gently into the staple unit until it clicks.

    Staple illustration

  9. Push the lever down until it clicks.

    Staple illustration

  10. Return the staple unit to its original position.

  11. Close the front cover of the finisher.

TopPreviousNext
Copyright (C) 2008